Troubleshooting & Repairs Solved
Engraving is fine, cutting suddenly stopped going through — same file as last week
Nothing changed. Same 3mm acrylic, same file, same settings. Last week it cut through in one pass, this week it doesn't.
Community seller
Bello Craft Files
Aisha Bello
@aishabello
- Birmingham, UK
- Joined November 2025
- Active 2 weeks ago
Jewellery cut files nested for zero waste
- Topics
- 2
- Replies
- 6
- Builds
- 1
- Files
- 2
- Followers
- 11
- Downloads
- 236
Nesting small parts: how I get six pairs of earrings from an A5 offcut
Small parts are where material cost quietly eats your margin. Three habits: 1. Shared cut lines. If two parts share a straight edge, put one line there, not two. Halves the cutting time on t…