Geometric earring set — 24 pairs, nested

2–3mm acrylic and 1.5mm veneer, jump-ring holes pre-sized and kerf-compensated

5.0(2) 174 downloads

£14.00

Commercial licence

Sell unlimited finished physical items you make. The file itself may not be redistributed.

Bello Craft Files2 files · 11 followers

Jewellery cut files nested for zero waste

About this listing

Twenty-four earring pairs drawn for small-format offcuts. Nested tightly so an A5 scrap yields six pairs with shared cut lines.

24 designs: arcs, stacked triangles, hex drops, crescents, layered rounds
Nested sheets at A5, A4 and 150 × 150mm
Hole sizes at 0.7mm and 1.0mm for jump rings, already kerf-compensated at 0.15mm
Layered variants where a second colour sits behind the first

LP4 diode and LP2 Plus, in 2mm and 3mm cast acrylic and 1.5mm birch veneer.

Every part has a 0.4mm retaining tab so pieces don't drop through honeycomb. Snip and sand — takes seconds and saves fishing parts out of the bed.

Cut the arcs in 1.5mm veneer and they're beautiful. Retaining tabs are a thoughtful touch.

Sold out of the hex drops at my last market. Nesting is genuinely tight — very little waste.